Safety instructions
5
AED9301B HBM
Safety instructions
There are not normally any hazards associated with the product, provided the notes and
instructions for project planning, assembly, appropriate operation and maintenance are
observed.
Each time, before starting up the modules, you must first run a project planning and risk
analysis that takes into account all the safety aspects of automation technology. This
particularly concerns personal and machine protection.
It is essential to comply with the safety and accident prevention regulations applicable to
each individual case.
Installation and start-up must only be carried out by suitably qualified personnel.
Do not allow the equipment to become dirty or damp.
During installation and when connecting the cables, take action to prevent electrostatic
discharge as this may damage the electronics.
The required power supply is an extra-low voltage with safe disconnection from the
mains.
When connecting additional devices, comply with the local safety requirements.
All the interconnecting cables must be shielded cables. The screen must be connected
extensively to ground on both sides.
The power supply and digital I/O connection cables only need to be shielded if the ca-
bles are longer than 30 m (32.81 yd) or are routed outside closed buildings.
The CE mark enables the manufacturer to guarantee that the product complies with the
requirements of the relevant EC directives (the declaration of conformity is available at
http://www.hbm.com/HBMdoc).
In accordance with national and local environmental protection and material recovery
and recycling regulations, old devices that can no longer be used must be disposed of
separately and not with normal household garbage.
If you need more information about waste disposal, please contact your local authorities
or the dealer from whom you purchased the product.
To Next Page
Loading...
