6.3.2 BOOSTING EQ : The EDB-2 VAP offers active boost as well
as cut on its EQ controls. However, boost functions can only work
effectively if there is a significant amount of the frequency already
there in order to be able to increase it.
The Harmonic Enhancer can apply high end content above 1 kHz
that would otherwise not be present. Fine tune, cut or boost via the
use of the Treble and Presence Control
For critical applications, EQ is generally thought to sound better
where cut rather than boosted
6.3.3 WHAT DETERMINES TONE? - There are a lot of interactive
influences. They include reflectiveness and brightness of the room,
what fixtures, fittings and people are in it, the size of the space, the
instrument type and every aspect of its construction and playing and
the amplification gear. EQ can compensate for a lot of these
influences
6.3.4 EQ CONTROLS - ROTARY POTS
Located on top
The Notch Filter and Range Switch settings can all overlap with
Bass, Low Mid and High Mid
i) BASS CONTROL: +/- 12dB centred broadly, approximately @
120Hz, or +/- 16dB if measured @ 45Hz….(and before you ask,
YES, these figures are both correct!) Allows control of the bass at
the lowest frequency of the audio spectrum and will overlap a little
tonally with Low Mid Control
P. 38
To Next Page
Loading...