8.1.2 MIC INPUTS XLR x 2
CH.1 AND 2 : Impedance < 3.4k Ohm. XLR input accepts dynamic,
ribbon, condenser, silicone Condenser (MEMS) and electret
condenser microphones
The XLR Ch.1 & 2 inputs allow the use of one to two high quality
condenser microphones. Microphones may be used in stereo
Uni-directional microphones such as cardiod and especially
hypercardiod polar patterns optimise volume levels in a live setting
before feedback occurs
A 3 way switch offers 10v or 48v phantom to XLR
10v is optimal for most electret condenser microphones or active
pickup systems while
48v is optimal for true condenser microphones
Headway XLR 3 pin wiring on inputs and outputs is at standard
configuration. See: Electrical Specifications 19.2 / Pickups and
Microphones 3.0 / Phantom Power 9.0
8.1.3 MICROPHONE SWITCHING
Located on top
2 Way Switch offers XLR ON/OFF Switch off when not in use to
save battery life and minimise noise
8.1.4 AUX IN: PSEUDO 3RD CHANNEL
Located on front end
P. 52
To Next Page
Loading...