Heath Zenith Motion Sensing Decorative Light
Models
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate, or install the product. This light fixture requires
120-volts AC. All wiring must be in accordance with the National Electrical Code (Canadian Electrical Code in Canada). Some local
electrical codes require installation by a qualified electrician.
WARNING: Turn power off at circuit breaker or fuse when wiring fixture or replacing bulbs. Place tape over circuit breaker switch and
verify power is off at the fixture.
CAUTION: Do not cut any wires that have factory installed wire connectors or remove the wire connectors.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. CAN ICES-3 (B)/NMB-3(B)
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with hardware contents list. If any part is
missing or damaged, do not attempt to assemble, install, or operate the product. Tools Required for Assembly (not included): Phillips
and flathead screwdrivers, pliers, wire strippers/cutters, multimeter, electrical tape, silicone sealant, safety glasses, work gloves, and
ladder
For easy installation and to operate the light using Manual mode, replace an existing light fixture operated by a wall switch.
To Next Page
Loading...
