1. To turn on MANUAL mode, switch the light off at the wall switch for 1 to 2 seconds and then back on.
2. To return to AUTO mode, switch the light off at the wall switch for 1 to 2 seconds and then back on.
Note: The sensor will also reset to AUTO mode at sunrise
CARE AND MAINTENANCE
To prolong the original appearance, clean with clear water and a soft damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature deterioration of the finish. This is
not a defect in the finish and will not be covered by the warranty.
Do not spray with hose or power washer.
TROUBLESHOOTING GUIDE
To Next Page
Loading...
