Why do my Heath Zenith 5408 lights come on for no apparent reason?
The Heath Zenith Home Safety Product lights might be turning on for no obvious reason because the light control is detecting small animals or car traffic. Try re-aiming the sensor. Alternatively, the sensitivity might be too high; try reducing it.
Why do my Heath Zenith 5408 Home Safety Product lights stay on continuously?
If your Heath Zenith Home Safety Product lights are staying on continuously, it could be due to several reasons. First, a flood lamp might be too close to the sensor or pointed at objects that trigger it; reposition the lamp. Second, the light control might be facing a heat source like an air vent; try repositioning the sensor. Finally, the light control might be in Manual Mode; switch it to Auto.
What to do if my Heath Zenith Home Safety Product lights flash on and off?
If your Heath Zenith Home Safety Product lights are flashing on and off, heat or light from the lamps might be turning the light control on and off; reposition the lamps away from the sensor. Reflected heat from other objects might also affect the sensor; reposition the sensor. If the light control is in Test mode and warming up, this flashing is normal. Light may also be leaking through the floodlamp reflectors; replace the lamps with new, high-quality PAR 38 lamps.
How to fix Heath Zenith Home Safety Product lights that will not come on?
If your Heath Zenith Home Safety Product lights will not come on, first, ensure the light switch is turned on. If it is, check if the flood light is loose or burned out; tighten or replace it. Also, verify that the fuse is not blown or the circuit breaker is not turned off; replace the fuse or turn on the circuit breaker. Ensure that the daylight turn-off is not in effect by checking the lighting after dark. If this is a new installation, check and correct the circuit wiring. Finally, re-aim the sensor to cover the desired area.
Why do my Heath Zenith 5408 Home Safety Product lights come on in daylight?
If your Heath Zenith Home Safety Product lights come on in daylight, the light control may be installed in a relatively dark location; relocate it to a darker area. Also, check if the light control is in Test mode; if so, set the control switch to an ON-TIME position.
Key operational aspects and benefits of the motion sensor light control.
Essential conditions and regulations for installing the light control.
Visual guide explaining how to change between TEST, AUTO, and MANUAL modes.
Instructions for correctly connecting the light control's wires to the power source.
Steps for securely attaching the light control fixture to the mounting surface.
Technical details including sensing angle, load capacity, and operating modes.
Contact information and procedures for obtaining technical assistance and support.
General| Brand | Heath Zenith |
|---|---|
| Model | 5408 |
| Category | Home Safety Product |
| Language | English |
To Next Page