EasyManua.ls Logo

Heath Zenith 5867 - IMPORTANT SAFETY AND INSTALLATION INFORMATION

Heath Zenith 5867
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 To see operational and troubleshooting information and videos,
go to www.hzsupport.com
208799-03
IMPORTANT SAFETY AND INSTALLATION INFORMATION
Before installing security light, read all instructions carefully and keep owners manual for future reference.
WARNING: To prevent electric shock, ensure that the power is disconnected before installation.
WARNING: Risk of re. Keep the lamp heads at least 2 in. from combustible materials.
WARNING: Shock hazard. For eave mounting, the center of the junction box must be located at least 4 1/2" (11.5 cm)
from the outside edge of the eave.
CAUTION: To avoid water damage and the risk of electrical shock, the motion sensor controls must be facing the
ground when the installation is complete.
CAUTION: Keep the lamp heads 30° below horizontal to avoid water damage and electrical shock.
CAUTION: Burn hazard. Allow the light xture to cool before touching.
NOTICE: Do not connect this light xture to a dimmer switch or timer.
is light xture requires 120-volts AC.
is light xture must be properly grounded.
Some electrical codes require installation by a qualied electrician.
If you want to use Manual Mode, the light xture must be wired through a switch.
is xture is designed for outdoor installation and should be mounted to a wall or eaves.
To achieve best results, this xture should be mounted 8 feet (2.4 meters) above the ground. Note: If xture is mounted
higher than 8 ft. (2.4 meters), aiming the sensor down will reduce coverage distance.
e motion sensor on this light xture detects motion by the movement of heat across the coverage area. e motion
sensor is more sensitive to the movement of heat moving across the coverage area and less sensitive to the movement
of heat directly towards it.
Note: Light xture and sensor should be mounted as shown above when installed (depending upon type of installation).
Least Sensitive Most Sensitive
Motion Motion
Sensor
Wall Mount Eave Mount
1 MIN 5 MIN
TEST 20 MIN
L M H
ON TIME
SENS.
180°
THIS SIDE UP
1 MIN 5 MIN
TEST 20 MIN
L M H
ON TIME
SENS.
180°
THIS SIDE UP

Related product manuals