Heathkit AA-1214 - Page 16

16
START
•
t .l.l, 5600 n (green-blue-red) .
NOTE : When installing electrolytic capaci-
tors, position the positive ( +) end as
shown.
(JJ.
100 1iF electrolytic.
IJ..I
100 µF eiectrol ytic.
(J.!
22 n (red-red-black).
~
1 Mn (brown-black-green).
( (11)
5600 n (green-blue-red).
(~
.22 µF polyester
(~
470 kn (yellow-violet-yellow).
t ,;J..1
.22 µF polyester
~
Solder the leads to the foil and cut
off the excess lead lengths.
~ HEATHKIT ~
=AMiiiMU-M
The steps performed in this Pictorial are in
this area of the circuit board.
IDENTIFICATION
DRAWING
PART
NUMBER
CONTINUE
2200 n (red-red-red).
) 220 n (red-red-brown).
NOTE : DIODES MAY BE SUPPLIED
I N A NY OF THE FOLLOWING SHAPES.
ALWA YS PO SITIO N THE BANDED EN
AS SHOW N ON THE Cl RC UIT BOARD.
MZ1000-24 diode
D111.
(#56 -64) at
~~~---..a..J (~ 1 N2071 diode (#57-27) at D110.
~~---JLJ 't:I( ) 1N2071 diode (#57 -27) at D109.
I
--
0
PICTORIAL 2-5
Install four 3A 1 diodes (#57-42). Be
sure to position the banded end of
each diode as shown on the circuit
board.
Solder the leads to the foil and cut
off the excess lead lengths.
NOTE : To install fuse clips in the
following steps, place a fuse clip into the
circuit board at each end of the fuse
outline. Be sure the shoulders of the clips
are at the outer end as shown.
Install two fuse cl ips and a 2-ampere
fuse (#421 -43) at Fl. Solder the
clip lugs to the foil (S-4).
~ SHOU LD ER)
\~~
r~Q)
,:
-
tll' l .
. ·. <I? · .: i~ l/ /, ,.
Install two fuse clips and a 2-ampere
fuse (# 421-43) at F2. Solder the
clip lugs to the foil (S-4).