Heathkit SW-717 - Chassis Parts Mounting

(
)
Bend the capacitor terminal away
from
the
chassis side
as shown.
(
)
Remove the
piece
of
gray
insulating
paper,
Save
the
paper
for use later.
6.32 NUT
EEND
SOLDER
LUG
SIRAIGHT
UP.
o
@
&
SCRTWDRIVIR
EHASSIS PARTS MOUNTING
Flefer
to
Fictorial
8
(fold-out
from Page
25)
for
the
foi!owing
steps.
OLDER LU
#6
S
'3t;J,i'&
()
{}
{}
{t
il
Refer
to
Detail
8A
and
install a 318"
grommet
in
the
chassis at
AM.
In a similar
rnanner, install a 1/4"
grommet
in the
side
of the
chassis
at 47.
Instali 3/1
6"
grommets
at
AN, AP,
AR, AX, and
AY.
Temporarily
push
the
piece
of
gray
insulating
paper
2"314"
x
2-314"|
into the corner
of the chassis
so it
touches both the chassis side
and
the
front chassis
ap!'{in,
as
shown
in the
Pictorial.
Mount ti-ie
5.9
pF
variable
capacitor at G on the
front
chassis apron.
Use
6-32
x
3/8"
screws through
grornmets
AX and AY.
Tighten cnly until
the
screw
heads are snug against
the
grommets,
Make sure
that
no
part
of this capacitor touches
the chassis.
Detail 8B
NOTE;
A
plastic
nut
starter
has
been
provided
with
this kit.
Use
it
to
hold and start
nuts
on screws. See
Page
3 of
the
"Kit
Builders
Guide" for more information.
Refer to
Detail
88
for the following steps.
(
)
Refer to
Part A of the
Detail and
mount a
#6
solder
lug on the
under side
of the
chassis at
AF.
Use
a 6-32
x 318" screw
and a 6-32
nut.
Position the solder
lug as
shown.
(
)
Refer to
Part B of the Detail
and bend
the
solder
lug
straight
up from the chassis.
632x318
SCREW
\
5.9
pF
VARIABLE
CAPACITOR
#
26-88
#6
SOLDER tUG
\
z
Detail
8C