35
Adding Freeze Protection Products
1) Remove the weighted pop off ball.
2) Drain the correct amount of water from the system for the products being added.
3) Take a funnel and place it into the relief vent pipe.
4) Pour the contents of the freeze protection products, into the HEATMOR™ furnace.
Do not pressurize the HEATMOR™; do not attempt to thread ttings onto the relief vent pipe and
“pump” additives into the HEATMOR™ under pressure.
5) Top off your furnace with water and ll your bladder. Refer to “Filling the Bladder Initially” for
details or contact your local dealer.
ABSOLUTELY NO FIRE IN THE FIREBOX WHEN PERFORMING THIS REPAIR. DO NOT
PERFORM THIS REPAIR WHEN UNIT WATER TEMPERATURE IS UNSAFE. ALWAYS WEAR PROPER
PERSONAL PROTECTIVE EQUIPMENT WHEN WORKING WITH WATER AND CHEMICALS.
To Next Page
Loading...
