74
Refer to:
• Checking for air leaks (Located in Air Leaks).
7. Q. Why am I experiencing an excess build up of creosote in the furnace?
A. You more than likely are introducing unwanted draft into the rebox. This may be caused by several
things, including a door ajar, ash auger tube cover loose, ipper assembly stuck. If your furnace
is in a location where wind may effect the pressure differential across the furnace, it could
cause draft to leak past the ipper.
Refer to:
• Creosote Build-up (Located in Trouble Shooting and Solutions).
8. Q. How do you change a door hose while the furnace is in operation?
A. Never change a door hose unless the furnace is cooled. Please refer to the rebox door hose
section in the manual for further details or contact your local dealer.
Refer to:
• Firebox Door Hoses and Elbows (Located in Firebox and Other Components).
9. Q. My furnace combustion blower continues to run but the fire will not burn until I open the
door?
A. Your ipper assembly is most likely stuck closed. Please refer to the combustion blower, ipper
assembly section in the manual for further details or contact your local dealer.
Refer to:
• Combustion Air Blower and Flipper Assembly (Located in Air Supply).
10. Q. Water is coming out of the rectangular top chimney flue?
A. Similar to the rebox, when your furnace is initially red up and also at times during normal
operation, the atmosphere inside the rebox and chimney ue will exceed the dew point causing
condensation.
Refer to:
• Furnace has excessive moisture in rebox (Located in Trouble Shooting and Solutions)
• Dew Point (Located in Safe Operating Guidelines).
To Next Page
Loading...
