70
SEASON START-UP MAINTENANCE CHECKLIST
To begin season start-up of your Heatmor
TM
Outdoor Furnace, assuming you followed the procedures
outlined in the “End of Season Maintenance Checklist,” follow the instructions below:
1. Remove cap from chimney.
2. Build re in rebox and bring your furnace up to temperature. (Refer to the “Lighting the Heatmor
TM
for the
rst time” section of the Heatmor
TM
Operations and Maintenance Manual.)
3. Once your furnace is up to temperature, you can start all pumps.
CAUTION: It is recommended to start your pumps AFTER you bring your furnace up to temperature. This
helps ensure your system isn’t air locked and ensure your water is circuating correctly.
4. Your start-up is complete.
CHAPTER 23
To Next Page
Loading...
