77
Water level low. Add Water.
Refer to
“Water Level Maintenance.”
Power loss.
Check Power Source
and GFI Reset
Refer to
“Electrical Supply.”
Pump malfunction.
Replace Pump or
Cartridge.
Contact your
Local Dealer.
Air trapped in water lines. Bleed lines.
Contact your
Local Dealer.
Malfunction of heating
appliances in building.
Repair, adjust or
replace.
Contact your
Local Dealer.
Furnace will not
burn properly
or will not
maintain water
temperature.
Chimney plugged. Clean Chimney.
Refer to
“Chimney Stub.”
Not enough wood in
Firebox.
Add wood.
Refer to
“Loading wood into the
HEATMOR™.”
Poor quality wood. Better wood.
Refer to
“Types of Wood.”
Draft ipper stuck.
Remove blower and
ipper assembly-clean,
lube or replace.
Refer to
“Steps to Maintain your
Blower and Flipper Assembly.”
Electrical power is off or
not constant.
Check all electrical
connections. Call
dealer or licensed
electrician.
Refer to
“Electrical (Contact Local
Dealer).”
Fire is out. Re-light re.
Refer to
“Lighting Your HEATMOR™.”
Flue plugged. Clean Flue.
Refer to
“Top Rectangular Flue.”
Blower ns are full of
dust.
Clean Blowers.
Refer to
“Steps to Maintain your
Blower and Flipper Assembly.”
PROBLEM CAUSE SOLUTION PROCEDURE
To Next Page
Loading...
