22 / 42
PL
SK
DE
EN
CS
HU
• Dangers caused by failing in ergonomic principles by construction of the product, for example
dangers caused by unhealthy position of body or excessive overcharge and unnature to
the anatomy of the human hand-arm, relate to construction of handle, equilibrium of the product.
• Dangers caused by unexpected starting, unexpected exceeding of engine revs caused by
defect / failure of control system, relate to the defects by the handle and placing of drivers.
• Dangers caused by impossibility to stop the product in best conditions, relate to solidity of
the handle and placing of engine shut down product.
• Dangers caused by defect of product control system, relate to solidity of the handle, placing
of drivers and marking.
• Dangers caused by shooting up of subjects or splashing of liquids.
• Mechanical hazard, caused by cut and throw off.
• Noise risk resulting in loss of hearing (deafness) and other physiological disorders (e.g. loss
of balance, loss of consciousness).
• Vibration risk (resulting in vascular and neurological harm in the hand-arm system, for
example so called “white finger disease”).
• Danger of fire or explosion relate to spilling of fuel.
UNPACKING
• Carefully check all parts after dismantling the transport box.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. There is a danger of swallowing or suffocating!
• If you notice transport damage or while unpacking, notify your supplier immediately. Do not
operate the product!
• We recommend save the package for future use. The packaging materials must still be
recycled or disposed of in compliance with the relevant legislation. Sort different parts of
the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
C Fasteners can become loose during transport in the packaging.
PACKAGE CONTENTS
1× machine body, 3× hose bands, 2× hose coupling, 2× sealing washer, 1× strainer, 1× socket
spanner fo spark plug, fasteners, 1× manual for use
• Standard accessories are subject to change without notice.
• This product requires assembly. The product must be assembled correctly before use.
ASSEMBLY
SUPPORT FOOTS ASSEMBLY
Install support foots (if not already installed) to the holders on the bottom of the frame using
screws enclosed (fig. 3).
CONNECT THE SUCTION HOSE
FIGURE 2
C The suction hose must be of reinforced, noncollapsible construction.
To Next Page
Loading...
