hecht 5041 - Battery Charge-Control Indication; Operating Instructions; Before Starting; Switch Buttons

30 / 48
PL
SK
DE
EN
CS
HU
4. Slide the battery into the battery holder (chamber) with light pressure so that the battery
contacts are firmly attached to the mower’s contacts (fig. 10BC).
5. Close the battery cover.
REMOVING THE BATTERY
1. Lift the battery cover (fig. 10A).
2. Press and hold the battery latch button (fig. 12).
3. Remove battery pack from the holder.
BATTERY CHARGE-CONTROL INDICATION
The battery and machine are equipped with a charge-control indicator which indicates its charge
condition. The charge-control indicator consists of 4 green LEDs.
Press the button to actuate the charge-control indicator. After approx. 5 seconds, the charge-
control indicator goes out automatically.
SIGNALIZATION ON THE BATTERY
Press the button (fig. 13A) to actuate the charge-control indicator.
LED signalization -  ON /  OFF /
Battery capacity
   
75 % - 100 %
   
50 % - 75 %
   
25 % - 50 %
   
< 25 %
The battery pack can be used as usual until
automatically turned off by the control program.
If the battery pack can not release power, the
battery pack needs to be charged.
When no LED lights up after actuating the button, the battery is defective and must be replaced.
For safety reasons, the charge condition of the battery can only be checked when the garden
product is at a standstill.
OPERATING INSTRUCTIONS
BEFORE STARTING
Always carry out a visual inspection before using your lawnmower to ensure that cutting tool,
retaining bolts and cable are not worn or damaged.
Carefully check the entire area to be mown and remove all foreign bodies.
C You must press at least two switching elements to start the motor.
SWITCH BUTTONS
• The switch button and switch lever are used to start and stop the motor and the blade.
When the buttons are released, the motor and blades stop.
• The switch button and switch lever are also a basic safety element of the mower.
• Before mowing, you should test switch functions several times to make sure everything is
working properly.
• If the switch buttons does not operate properly, contact an authorized service center.