hecht 5041 - Storage; Folding the Mower for Storage

37 / 48
PL
SK
DE
EN
CS
HU
edge receives an equal amount of grinding to prevent an unbalanced blade. Improper blade
balance will result in excessive vibration causing eventual damage to the motor. The blade
can be tested for balance for example by balancing it on a round shaft screwdriver. Remove
metal from the heavy side by grinding until it balances evenly.
7. Place the blade with the part number facing away from the adapter. Align the washer over
the blade and insert the hex bolt. Tighten the hex bolt to the torque listed in the Specifications.
C When you change the blade, must use the original blade (for order the blade, please
contact your local dealer or call our company).
• To insure safe operation of your unit. ALL nuts and bolts must be checked periodically for
correct tightness.
• After prolonged use, especially in sandy soil conditions, the blade will become worn and
lose some of the original shape. Cutting efficiently will be reduced and the blade should
be replaced. Replace with an approved factory replacement blade only. Possible damage
resulting from blade unbalance condition is not the responsibility of the manufacturer.
• When you change the blade, must use the original blade (for order the blade, please contact
your local dealer or call our company).
CAUTION! A
Do not touch rotating blade.
STORAGE
• Store the machine out of reach of children.
• Turn the motor off and unplug the power supply.
• Allow let the machine to cool down before storage.
• Do not store the machine a long time in direct sunlight.
• Replace worn or damaged parts for safety.
• Store machine in a clean, dry, dark and frost-free place, protected from dust and out of
reach of children. The ideal storage temperature is between 5 and 30°C.
• Use the original packaging to storage whenever possible.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.
• Be careful not to bend or kink cables, when folding and unfolding the handle.
Note: I When storing care should be taken to rust-proof the equipment. Using a light oil or
silicone, coat the equipment, especially all metal parts and all moving parts.
FOLDING THE MOWER FOR STORAGE
1. Raise the rear cover and remove the grass catch bag.
2. Move the height adjustment lever toward the front and engage it in the “2” position.
3. Release the locking knobs on both sides (fig. 22), rotate the lower handle from working
position to folding position. Make sure that the pin on the handle is seated in the individual
bore-hole on the machine.
4. Store the mower flat or upright (fig. 23).