34 / 48
PL
SK
DE
EN
CS
HU
FOR THE BEST RESULTS MOWING
C Your mower is designed to cut normal residential grass of a height no more than
250 mm.
• Clear lawn of debris. Be sure that the lawn is clear of stones, sticks, wire or other foreign
objects which could be accidentally thrown out by the mower or wrapped around
the rotating parts. It may cause serious personal injury to the operator and others as well as
damage to property and surrounding objects.
• Do not attempt to mow high dry grass or large amount of dry leaves. If the dirt is clogged
on the blade or the chassis, the engine and blade, etc., can become damaged. Dry material
may also come into contact with the engine exhaust and subsequently cause ignition.
• When mowing damp or wet grass, the grass sticks to the discharge tunnel and then
becomes clogged. Clogging makes the collection and ejection of grass impossible and
causes a disproportionate engine load. We don’t recommend cutting damp and wet grass.
• To avoid stirring up the dust, mow the grass best when it´s is dry, but the soil is still moist.
• Ground speed will need to be adjusted so the clippings can be dispersed evenly into the lawn.
• For especially heavy cutting in thick grass it may be necessary to use one of the slowest
speeds in order to get a clean well mowed cut. When mowing long grass you may have to
cut the lawn in two passes, lowering the blade another 1/3 of the length for the second cut
and perhaps cutting in a different pattern than was used the first time.
• Cut the grass regularly. With respect to the lawn, do not cut by more than 1/3 of the total
height (to prevent it from withering). However, cut the grass by approximately 2 cm (i.e.
shorten it from 6 cm to 4 cm, for example).
• Always keep the edge of the cutting blade sharp.
• Only move at working pace.
• Always keep the grass ejection hole clean and clear. Remove cut material only when
the equipment is stopped.
• Overlapping the cut a little on each pass will also help to clean up any stray clippings left
on the lawn.
• Clean underside of deck. Be certain to clean the underside of the cutting deck after each use
to avoid a build-up of grass, which would prevent proper mulching.
• The mowing of leaves can also be beneficial to your lawn. When mowing leaves make sure
they are dry and are not laying too thick on the lawn. Do not wait for all the leaves to be off
the trees before you mow.
CAUTION! A
If you hit a foreign object while working, stop the mower and remove the battery.
Thoroughly inspect the mower for any damage and repair the damage before
restarting and operating the mower. Extensive vibration of the mower during
operation is an indication of damage (especially blade and shaft). The mower should
be promptly inspected and repaired. Contact an authorized service center.
To Next Page
Loading...
