29 / 46
Note: I
NEVER hold the cable other than by the handle. (e.g. wrapped around your wrist)
• Repeat until the start of the engine.
• If the decompression valve is installed, it automatically closes when the engine is started.
• Allow the engine to warm up with a slightly pressed gas lever (fig. 10) (,,a" gas + ,,b" lock).
After pressing the gas lever, the choke rod is released.
• The engine will operate at idle running after releasing the gas lever.
• Release the brake by pulling the front hand guard to the front handle when idling and
the chainsaw lying down (fig. 3) (a).
• Do not use the injector or the choke when starting a heated chainsaw.
Note: I
This is a general procedure. In the course of use, however, you may find the ideal
“trick” for easy starting of your chainsaw. Each behaves a little bit differently, and so in some
cases, if the engine dips with the choke and immediately goes out after a few attempts to
start it, the choke should be turned off by the gas lever and continue the starting without it.
BAR LUBRICATION CHECK
After starting the engine and releasing the brake, spin the chain at medium speed and check
that oil is sprayed off from the chain. Turn the tip of the bar against the base with the spinning
chain. Sprayed oil must create a print on the base within several seconds (fig. 11).
The amount of oil and lubrication intensity can be controlled by the ‘Bar lubrication adjustment’
screw, located at the bottom of the saw.
STOPPING THE ENGINE
• At idle running, switch the ignition switch to ‘O’ (STOP). (fig. 12 a).
MAINTENANCE AND STORAGE
CAUTION! A
To ensure proper functioning of the machine, it is necessary to have it checked and
adjusted by qualified personnel in an authorized service centre at least once a year.
Proper maintenance is essential for safe, economic and trouble-free operation of
the machine.
Failure to follow the maintenance instructions and safety precautions may cause serious injury
or death. Always follow the procedures, safety precautions, recommended maintenance and
recommended checks mentioned in this manual.
WARNING! B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
for all moving parts to stop and allow the machine to cool down. Prevent the engine
from being started incidentally (disconnect the power unit from the mains).
THIS WARNING IS NOT REPEATED IN ANY FOLLOWING POINTS!
HECHT_925_R_MANUAL_2022_EN.indd 29HECHT_925_R_MANUAL_2022_EN.indd 29 28.03.2023 11:58:0328.03.2023 11:58:03
To Next Page
Loading...