hecht 925 R - De; Felling of Trees; Storage

38 / 46
PL
SK
DE
EN
CS
HU
WARNING! B
Never cut with the top of the bar tip. There is a high risk of kickback towards you
(fig. 21).
- Never stand over the chainsaw. Some part of the body could come into contact with
the spinning chain due to inertia in the case of kickback or chain breakage.
- Always stand firmly with both feet on the ground and remove the cut material in time.
Hold the chainsaw firmly with both hands.
- Do not cut if you need to reach out. Never out of the ladder or above the shoulder level.
- It must be secured against spinning when cutting round timber.
- Do not try to cut thicker materials and logs with one cut.
- Always be aware of which side the tension is on and cut the side of the material which
is stressed roughly to one third when cutting (e.g. the underside of loose-hanging
branches, the upper side of logs leaning from both sides, etc.). Finish the cutting from
the other side only after cutting from the side which the stress can be on. This prevents
the bar and chain clamping (fig. 22) and (fig. 23)
- Be aware of where the cut off material will fall or where it can be thrown off.
- Be careful about the cut branches being back-sprung!
FELLING OF TREES
WARNING! B
Felling trees does is not a job that should be done in a layman’s fashion. If necessary,
entrust this work to experts.
STORAGE
Long-term storage (over 30 days)
CAUTION! A
Do not store the chainsaw in an enclosed space where flammable vapours may
accumulate or where they can come into contact with open flame or spark.
If you intend to store the machine for a long period of time, perform the following steps within
maintenance:
- Remove any dirt from the chainsaw external surfaces.
- Remove the clutch cover and remove any dirt from the brake caliper, clutch, and chain
using a brush.
- Remove the bar and chain, clean the guide groove (and remove any burrs, see BAR
MAINTENANCE)
- Check the condition of the chain (have it sharpened if necessary)
- Install the bar, chain and clutch cover. Tighten the chain properly.
- Remove the filter cover and clean the filter.
- Remove debris and impurities with a brush from the cylinder area.
- Clean or replace the spark plug.
- Put the filter cover back.
HECHT_925_R_MANUAL_2022_EN.indd 38HECHT_925_R_MANUAL_2022_EN.indd 38 28.03.2023 11:58:0428.03.2023 11:58:04