32
1.3 Data Transfer from the Programming Station to the Machine Tool
Calling a program from the machine tool
U Select the Programming and Editing operating mode
U Press the PGM MGT key to call the file manager
U Select the target directory to which you want to copy the program
created with the programming station
U Select the split-screen view
U In the right-hand window, select the <c:\pgmtransfer> directory on
the programming station PC
U Select the program to be transferred, and transfer it to the machine
tool
Connection between the programming station
and HEIDENHAIN PC software
To be able to set up a connection between HEIDENHAIN PC software
(e.g. TNCremo NT or CycleDesign) and the programming station, the
programming station has a special IP address, the so-called loop-back
IP. This loop-back IP is 127.0.0.1 and must be entered in the
appropriate configuration menu of the HEIDENHAIN PC software.
Then you can set up a connection with the programming station, as if
you were connected with a machine.
Refer to the TNC User’s Manual for more information
about copying files.
To Next Page
Loading...
