46
2.2 Connecting the Programming Station
Configuring the programming station software
for use with an USB network dongle
All computers to which you want to give access to a network dongle
must be configured in the following way:
U Start the programming station software
U Double-click the green HEIDENHAIN symbol to the lower right in
the task bar for the iTNC control panel to appear (see figure)
U Click the More >> button: Additional settings are displayed
U Click the Settings button: Programming station settings are
displayed
U Select the Use Hardlock Server option
U If required, select whether you are using a programming station
(Programming Station is the default setting) or VirtualTNC (Virtual
Machine)
U In the Server input field, you enter the IP address or the network
name of the computer which you are using as a server, i.e. the
computer to which you have connected the USB network dongle
U To confirm your settings, press OK
Changes do not take effect until you restart the
programming station software: Press the Restart iTNC
button.
You do not need to install any additional drivers on the
client PC to be able to access the USB network dongle.
To Next Page
Loading...
