8 Programming: Cycles
154
8.2 Drilling Cycles
The TNC offers 9 cycles for all types of drilling operations:
Cycle Soft key
1 PECKING
Without automatic pre-positioning
200 DRILLING
With automatic pre-positioning and
2nd set-up clearance
201 REAMING
With automatic pre-positioning and
2nd set-up clearance
202 BORING
With automatic pre-positioning and
2nd set-up clearance
203 UNIVERSAL DRILLING
With automatic pre-positioning,
2nd setup clearance, chip breaking, and decrement
204 BACK BORING
With automatic pre-positioning,
2nd set-up clearance
2 TAPPING
With a floating tap holder
17 RIGID TAPPING
Without a floating tap holder
18 THREAD CUTTING
8.2 Drilling Cycles
kkap8.pm6 30.06.2006, 07:03154
www.EngineeringBooksPdf.com
To Next Page
Loading...
