EasyManua.ls Logo

HEIDENHAIN TNC 426 B

HEIDENHAIN TNC 426 B
362 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 MOD Functions
308
12.5 Ethernet Interface
Setting Meaning
DCM Here you enter the rights of access to files on
the NFS server (see figure at upper right).
Enter a binary coded value.
Example: 111101000
0: Access not permitted
1: Access permitted
DCM Here you enter the rights of access to files on
the NFS server (see figure at upper right).
Enter the value in binary coded form.
Example: 111101000
0: Access not permitted
1: Access permitted
AM Definition of whether the TNC upon switch-on
should automatically connect with the
network.
0: Do not connect automatically
1: Connect automatically
Defining the network printer
ú
Press the DEFINE PRINT soft key if you wish to print the files on
the network printer directly from the TNC.
Setting Meaning
ADDRESS Address of your server. Input: four decimal
numbers separated by points. Ask your
network manager for the number of your
address. e.g. 160.1.13.4.
DEVICE NAME Name of the printer that the TNC shows when
the PRINT soft key is pressed (see also „4.4
File Management with Additional Functions“)
PRINTER NAME Name of the printer in your network. Ask your
network manager.
Checking the network connection
ú
Press the PING soft key.
ú
Enter the Internet address of the device with which you wish to
check the connection, and confirm your entry with ENT. The TNC
transmits data packets until you exit the test monitor by pressing
the END key.
In the TRY line the TNC shows the number of data packets that
were transmitted to the previously defined addressee. Behind the
number of transmitted data packets the TNC shows the status:
Status display Meaning
HOST RESPOND Data packet was received again, connection is
OK.
TIMEOUT Data packet was not received, check the
connection.
CAN NOT ROUTE Data packet could not be transmitted. Check
the Internet address of the server and of the
router to the TNC.
111101000
All other users: Search
All other users: Write
All other users: Read
Work group Search
Work group: Write
Work group: Read
User: Search
User: Write
User: Read
Okap12.pm6 30.06.2006, 07:04308
www.EngineeringBooksPdf.com

Table of Contents

Related product manuals