HEIDENHAIN TNC 426 B

HEIDENHAIN TNC 426 B, TNC 430 331
13.1 General User Parameters
Maximum contouring speed at a feed rate override setting of 100% in the program run modes
MP7470
0 to 99 999 [mm/min]
Datums from a datum table are reference to the
MP7475
Workpiece datum: 0
Machine datum: 1
Running pallet tables
MP7683
Program run, single block: Run one line of the active NC program at
every NC start: +0
Program run, single block: Run the entire NC program at every NC
start: +1
Program run, full sequence: Run the entire NC program at every NC
start: +0
Program run, full sequence: Run all NC programs up to the next pallet
at every NC start: +2
Program run, full sequence: Run the entire NC program at every NC
start: +0
Program run, full sequence: Run the entire pallet file at every NC start: +4
Program run, full sequence: Run the entire pallet file at every NC start: +0
Program run, full sequence: If running of the complete pallet file is
selected (+4), then run the pallet file without interruption, i.e. until you
press NC stop: +8
Pkap13.pm6 30.06.2006, 07:04331
www.EngineeringBooksPdf.com