M Effect of M function Effective at block - start end page
M00 Stop program run/spindle STOP/coolant OFF
■
135
M02 Stop program/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 ■ 135
M03 Spindle ON clockwise
■
M04 Spindle ON counterclockwise
■
M05 Spindle STOP ■ 135
M06 Tool change/Stop program run (depending on machine parameter)/Spindle STOP
■
135
M08 Coolant ON
■
M09 Coolant OFF
■
135
M13 Spindle ON clockwise/coolant ON
■
M14 Spindle ON counterclockwise/Coolant ON
■
135
M30 Same function as M02
■
135
M89 Vacant miscellaneous function or
■
Cycle call, modally effective (depending on machine parameter)
■
153
M90 Only in lag mode: Constant contouring speed at corners
■
138
M91 Within the positioning block: Coordinates are referenced to machine datum
■
135
M92 Within the positioning block: Coordinates are referenced to position defined
by machine tool builder, such as tool change position
■
135
M94 Reduce display of rotary axis to value under 360°
■
145
M97 Machine small contour steps
■
139
M98 Machine open contours completely
■
140
M99 Blockwise cycle call
■
153
M101 Automatic tool change with replacement tool if maximum tool life has expired
■
M102 Reset M101
■
77
M103 Reduce feed rate during plunging to factor F (percentage)
■
141
M105 Machining with second kv factor
■
M106 Machining with first kv factor
■
330
M107 Suppress error message for replacement tools
■
M108 Reset M107
■
77
M109 Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
■
M110 Constant contouring speed at tool cutting edge
(feed rate decrease only)
■
M111 Reset M109/M110 ■ 142
M114 Automatic compensation of machine geometry when working with tilted axes:
■
M115 Reset M114
■
146
M116 Feed rate for angular axes in mm/min
■
M117 Reset M116
■
144
M118 Superimpose handwheel positioning during program run ■ 143
M120 Pre-calculate radius-compensated contour (LOOK AHEAD)
n
142
M126 Shorter-path traverse of rotary axes
■
M127 Reset M126
■
144
M128 Maintain the position of the tool tip when positioning with tilted axes (TCPM)
■
M129 Reset M128
■
147
M130 Moving to position in an untilted coordinate system with a tilted working plane
■
137
M134 Exact stop at nontangential contour transitions when positioning with rotary axes
■
M135 Reset M134
■
148
M200 Laser cutting: Output programmed voltage directly
■
M201 Laser cutting: Output voltage as a function of distance
■
M202 Laser cutting: Output voltage as a function of speed
■
M203 Laser cutting: Output voltage as a function of time (ramp)
■
M204 Laser cutting: Output voltage as a function of time (pulse)
■
149
Miscellaneous functions
URÜCKSE.PM6 30.06.2006, 07:04323
www.EngineeringBooksPdf.com
To Next Page
Loading...
