Assembly
19
Assembly
Install support rod
On the back side of the unit you will nd a slot to install the support rod.
To install the support rod you require a TORX screw driver T20.
The back support rod allows you to attach
the stirrer to a stand in conjunction with a
2-way clamp or to a wall grid.
Threaded hole
Support rod
Threaded screw
➜ Install the support rod in the slot on
the back side of the unit.
Slot on the back
side of the unit
➜ Ensure that the threaded hole in the
support rod aligns with the drill hole in
the housing.
Threaded hole
Drill hole housing
➜ Secure the support rod with the
threaded screw supplied.
Secure with
threaded screw
To Next Page
Loading...
