What to do if my Heidolph Laboratory Equipment unit cannot be switched on?
If your Heidolph Laboratory Equipment unit won't switch on, there are a couple of things to check: * Make sure the main plug is properly connected to the power supply. * Inspect the fuses; if they are defective or blown, replace them.
Why is there no heating function in my Heidolph Laboratory Equipment?
If there is no heating function in your Heidolph Laboratory Equipment, consider the following possible causes: * The master switch may be deactivated. If so, activate the main switch. * The connecting cable of the heating bath may not be connected. Connect the connecting cable of the heating bath. * The maximum temperature limiter may have responded. If the medium was in the heating bath: Let the heating bath cool and re-set the maximum temperature limiter.
What to do if the motor lift is not functioning in my Heidolph Hei-VAP Precision Laboratory Equipment?
If the motor lift isn't working on your Heidolph Laboratory Equipment, try these: * Ensure the master switch is activated. * If the lift is at the end stop, activate the other arrow key.
What to do if the drive unit is not rotating in my Heidolph Hei-VAP Precision?
If the drive unit isn't rotating on your Heidolph Laboratory Equipment, here's what you can check: * Make sure the speed controller is not on the left stop. If it is, turn the speed controller to the right.
General| Brand | Heidolph |
|---|---|
| Model | Hei-VAP Precision |
| Category | Laboratory Equipment |
| Language | English |
To Next Page