Operation
40
Menu topology
Actual value display for all modes
Menu entry Value range
Vacuum 1 and 1200 mbar; default value: 1000 mbar
Dampf Vapor temperature measured at the vapor temperature sensor.
Rotation 10 and 290 rpm in 1 rpm increments; default value: 100 rpm
Heating bath 20 °C and the max. temperature of the heating bath (to be
assigned in Setup), however, no more than 210 °C
Softkey 1 Start Vacuum
Softkey 2 Start all / Stop all
Softkey 3 Max. Vacuum
Softkey 4 Stop Vacuum
SET pressure mode
Menu entry Value range
Heating bath 20 °C and the max. temperature of the heating bath (to be
assigned in Setup), however, no more than 210 °C.
Rotation 10 and 290 rpm in 1 rpm increments; default value: 100 rpm
Vacuum 1 and 1200 mbar; default value: 1000 mbar
Hysteresis 1 to 50 mbar; default value: 10 mbar
Timer 1 to 1440 min; in 1 min; default value: 0 min; 0=off
Accept (OK)
Softkey 1 Store Favorite
Softkey 4 Esc
Auto easy mode
Menu entry Value range
Heating bath 20 °C and the max. temperature of the heating bath (to be
assigned in Setup), however, no more than 210 °C.
Rotation 10 and 280 rpm in 1 rpm increments; default value: 100 rpm
Pump type “vario control” and “vario tec” ; default value: “variocontrol” Blank
out by using vacuum-valve
Timer 1 to 1440 min; in 1 min; default value: 0 min; 0=off
Accept
Softkey 1 Store Favorite
Softkey 4 Esc
To Next Page