Leave it to stand for 2 hours after transporting. Before first use, please use a soft fabric to clean the inside
surfaces of the drum.
a)Put some clean rags into the drum.
b)Plug the power cord, press 【On/Off 】.
c)Select the 【Refresh】Program, press 【Start/Pause】 button.
d)After finishing this program, please follow the “cleaning and routine maintenance” to clean the filter door.
During drying, the compressor and the water pump generate some noise which is entirely normal.
.
Level adjusting
Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level.
If it is not, adjust the feet with a tool.
Power supply connection
1.Make sure that the voltage of the power supply is the same as the one specified on the dryer.
2.Please do not connect it with the power connection board, universal plugs or sockets.
To Next Page
Loading...
