Clean filter base
1.Open the filter cover.
2.Unscrew both locking levers towards each other.
3.Clean the filter base completely.
4.Re-insert the filter base!
5.Screw both locking levers.
6.Close the filter cover flap until it locks into position.
NOTE!
1.The fluff accumulated on the filter will block the air circulation, which will cause the extension of drying
time and energy consumption;
2.Do disconnect the power cord before cleaning!
3.Do not operate the dryer without the filter!
4.Clean the filter after each use to prevent lint accumulation inside the dryer.
Clean heat exchanger
As necessary, approximately once every 2 months, remove the fluff from the heat exchanger using the
sponge or soft brush.
When doing this, please use gloves.
Note: The fluff can be removed more easily if it is first dampened e. g. with a laundry dampener.
To Next Page
Loading...
Need help?
General
