Special drying function
1. Instructions on 【Delay】 drying procedure
To delay the drying program from 0 hour to 24 hours. The delay time means the program will
start after x hours. When the delay program starts, the time starts to decrease on the display
and the icon blinks.
Steps in details
-Load your laundry and make sure the machine door is closed.
-Press the 【On/Off】button, then turn the program selector knob and select a desired
program.
-You can select the 【Anti-Crease】 or 【Signal】functions according to your need.
- Press the 【Delay】 key.
-Continue to press the 【Delay】to select the delay time.
-After the 【Start/Pause】 button is pushed, the dryer is at the run condition. The drying
procedure will be automatically performed when the delay time is over.
-If you push the【Start/Pause】button again, the delay function will be paused.
-If you want to cancel the “Delay” function, please press the 【On/Off】button.
2. Instructions on 【Time】 function
When the time program is selected, the 【Time】 button can be used to adjust the drying time
in 10 min. steps. The maximum time is 150 min.
3. Instruction of the 【Intensity】 function
Used to adjust the dryness level of the laundry. The level has four grades . The
drying time increases 3 minutes in every grade.
-The intensity function can be activated only before the program start.
-Press the 【Intensity】 button repeatedly to select the drying time.
- Except the 【Cotton Iron】【 Delicate】【 Synthetic Iron】 【Wool】【 Time】, all the other
programs can be set the 【Intensity】 function.
4. Instruction of the【My Cycle】function
Used to define and save your favorite Programs that are used frequently.
-Use the program selector to select the required program and other drying functions.
-Press and hold the 【Intensity】 button for 3 seconds until the beep, and the required
program has been saved.
-Turn the program selector to the 【My Cycle】 position, you can start your favorite programs.
If you want to change the 【My Cycle】 settings, repeat the steps (1) and (2).
5. Instruction of the 【Lamp】
The lamp inside the drum will stay on for about 3 minutes when the button is pressed or 1
minute after opening the door.
To Next Page
Loading...
Need help?
General
