Select the program
1.Press the【On/Off 】 key, when the LED display screen brighten up, rotate the program
knob to select the desired program.
2.Select the【Delay】,【Time】,【Intensity】,【Signal】or【Anti-Crease】functions for
additional options.
3.Press the【Start/Pause】key.
Program start
The drum will keep rotating after the program start, the state light in the display area will flash in
sequence, and the remaining time displayed will change automatically.
Note:
Occasionally , the drum might suspend about 40 seconds during the drying procedure, but the
screen displays normal. The dryer is automatically adjusting and will continue operation.
Program end
1.The drum will stop running after the program ends, the display will show " ", the last cycle
phase status light will flash. The dryer will start 【Anti-crease】 function if user doesn’t remove
the load in time. Please press 【On/Off】 key to cut off power and pull the plug out.
2.Deal with the problem according to “Malfunction display and solutions”, if there is an
unexpected stop during the drying procedure and the dryer shows information.
To Next Page
Loading...
Need help?
General
