Heinzmann PANDAROS III DG 16.6 - User Manual

Copyright 2014 by Heinzmann GmbH & Co. KG. All rights reserved.
This publication may not be reproduced by any means whatsoever or passed on to any third parties.
6685 Manual DG 01 010-e / 01-14
Heinzmann GmbH & Co. KG
Engine & Turbine Management
Am Haselbach 1
D-79677 Schönau
Germany
Phone +49 7673 8208-0
Fax +49 7673 8208-188
E-mail info@heinzmann.com
www.heinzmann.com
V.A.T. No.: DE145551926
HEINZMANN
®
Digital Speed Governors
Digital Basic System
PANDAROS - III
DG 16.6 - 01 up to - 05
DG 30.6 - 01 up to – 05
DG 40.6 - 01 up to - 05

Heinzmann PANDAROS III DG 16.6 Specifications

General

Brand	Heinzmann
Model	PANDAROS III DG 16.6
Category	Controller
Language	English

Summary

Safety Instructions and Symbols

Hazard Signal Words and Symbols

Explains DANGER, WARNING, CAUTION, NOTICE signals and hazard warning triangles.

Basic Safety Measures

Guidelines for safe operation, servicing, maintenance, and post-repair checks.

Functions

General Functions

Covers start quantity, speed ramps, droop, speed range, engine stop, overspeed protection, PID correction.

Variation-Specific Functions

Sensors

Magnetic Pick-up Sensor

Boost Pressure Sensors

Setpoint Adjusters

Setpoint Potentiometers

Specifications for 1-turn (SW 01) and 10-turn (SW 02) setpoint potentiometers.

Alternative Setpoint Adjustment Methods

Control Unit DC 6-01... 05

Control Unit General Specifications

Electrical, environmental, and physical specifications of the DC 6 control unit.

Control Unit Inputs and Outputs

Actuators

Actuator Design, Operation, and Advantages

Actuator Installation and Specifications

Regulating Linkage

Lever Arm and Connecting Linkage Setup

Electrical Connection

Connection Diagrams for PANDAROS Variations

Wiring schematics for DG 6-01, DG 6-02, DG 6-03, DG 6-04, DG 6-05.

Harnessing and Cable Specifications

Parametrization Options

Parametrization Methods and Tools

Describes factory, handheld programmer, and PC-based parametrization procedures.

Data Management and Programming

Starting the Engine

Brief Engine Start-up Instructions

Step-by-step guide for starting the engine, including calibration and parameter checks.