9. Periodic Maintenance:
Full inspections on truck can prevent faults and that the truck cannot live up to its service life. The
hours listed in the maintenance procedures are based on the condition that the truck works 8 hours per day
and 200 hours per month. For safe operations, please maintain the truck according to the maintenance
procedures.
Attention
All the repair work should be conducted by professionals.
For the service work such as adjusting or replacing spare parts, please contact our sales department.
9.1 Precautions for maintenance:
Attention
Replace by the authentic spare parts of our company. All the spare parts should be
replaced by those of equal safety requirements with the original design. Adopt the
recommended lubrication oil and hydraulic oil.
Attention
It should be an appointed place, able to provide service mechanisms like hoisting
and safety protective devices.
It should be a flat ground.
It should be well-ventilated.
It should be equipped with firefighting devices
Precautions before maintenance:
Attention
No smoking.
Ensure self-protection.
Wipe out the run out oil timely.
Before add lubrication oil, first clean the dirt oil or dust on the joints with a brush or
cloth.
Except for some occasions, turn off the key switch and plug out the power socket.
When maintaining the truck, place the forks to the lowest position.
When disassembling high-pressure oil pipe, make sure there is no cargo on the
truck and the forks are in the lowest position, in order to release the pressure within
hydraulic system.
Before contact the main circuit terminal, first discharge the circuit. There is a
capacitor in the circuit, and a small amount of electricity may exist.
Clean the electrical part with compressed air; never clean it with water.
When it is required to maintain the truck at heights, the maintenance personnel
should be protected.
9.2 Inspections and maintenance before starting a new truck
In order to conform to relative industrial regulations and ensure absolute safety of truck during
transportation, it is probable that the battery is not equipped with electrolyte (except for inland sales) before
starting for the first time.
When the truck leaves the factory, the prepared electrolyte is with it. Before first use, pour the
electrolyte into the battery by professional personnel. First, place the truck in a well-ventilated place, open
the cap of the battery box, and open the plastic cap on the battery top completely. Lift the plastic pot filled
To Next Page
Loading...
