Brief Introduction of Structure (refer to structural
drawings and schematic drawings of main components)
The truck is mainly composed of truck frame, mast column, lifting oil cylinder, operation handle, steering
mechanism, drive wheel, battery pack, hydraulic power unit, electric control system and so on.
3. Safety Norms
Warning
Pay attention to the following items before using the truck:
The electric truck is designed for hard and flat indoor ground; never use it in a flammable or explosive
environment, or a corrosive environment like acid or alkali.
Only trained and recognized drivers are allowed to drive this truck.
Please read this manual carefully and grasp the performance of truck before operate it; everytime before
use, check carefully whether the truck is in a normal state; never use a faulted truck; never repair the truck
unless you’ve been trained on it.
Overloading is strictly prohibited.
Never press the lifting/lowering button while the truck is travelling; never switch the lifting/lowering button
in a fast and frequent manner because it will cause damage to truck and cargo!
Do not leave cargo on the truck for an extended period of time!
Never make sharp turns in narrow aisles when you should decelerate and turn slowly to ensure safety of
personnel and cargo.
Never put any part of human body under truck frame or standing platform!
This order picker is designed for operations on a flat ground or flat working platform; never park it or use it
on a ramp.
Overloading or overramp running is strictly prohibited, otherwise wheels will skid, damaging wheels and
motor as well as impairing safety of cargo and human bodies.
Never use the truck below the specified voltage 20.4V.
Never charge by connecting the plug with AC power directly.
3.1 Norms for safe operations:
Training of drivers:
To Next Page
Loading...
