HellermannTyton AT2000 CPK bench mount kit - 1 User Information; Field of Application; Warranty; Manufacturer Contact Data

ENDE
Operating Instructions • Bench Mount Kit AT2000 CPK • 03/2020 • 106-29020
User information
4
1 User information
These operating instructions are an essential aid for
proper operation of the AT2000CPKbenchmountkit.
They contain important information and safety
instructions to properly set up the products as well as for
their intended and economical use.
1.1 Field of application
The operating instructions are directed towards
technicians and the operator.
These operating instructions only apply for the following
AT2000CPKbenchmountkit, referred to in the following
as “bench mount” and the associated Autotool2000CPK
tool, referred to as “tool” in the following.
TYPE Article No.
AT2000CPKbenchmountkit 106-00040
Autotool 2000 CPK 106-00000
1.2 Warranty
The warranty complies with the statutory requirements.
Warranty claims are only valid in the country where the
products were purchased.
1.3 Manufacturer contact data
The manufacturer of the product described in these
instructions is:
HellermannTyton GmbH
Großer Moorweg 45
D-25436 Tornesch
Tel. +49 4122 701-0
www.HellermannTyton.de
Info@HellermannTyton.de
1.4 Information on the operating instructions
Last change: 13.3.2020
1.5 Copyright and intellectual property rights
The manufacturer retains the copyright for this manual.
No part of this manual may be reproduced in any form
without the written consent of HellermannTyton GmbH
(called HellermannTyton in the following), nor may it be
processed, duplicated or distributed using
electronic systems.
Actions that violate the aforementioned statements will
require payment of damages.
1.5.1 Used labels and symbols
In these operating instructions, different labels and
symbols are used in the text. These are explained in
the following:
f Symbol for an instruction
• Symbol for an enumeration
1 First step
2 Following steps
; Outcome
Text that is à highlighted in this manner indicates cross-
references.
Messages with this symbol contain information about the
environment and how you can help protect it.
Texts with this symbol contain additional information.
1.6 Keeping and handing over these instructions
These operating instructions must be kept in the
immediate vicinity of the workplace and must be available
to all personnel at all times. The operator must inform the
personnel about where this manual is kept. If the manual
should no longer be legible, the operator must procure a
replacement from the manufacturer.
When the products are handed over or sold to third
parties, the following documents must be handed over to
the new owner:
• this manual
• documents regarding repair work
• verification of maintenance work
1.7 Target group of these instructions
The instructions must be read and observed by all persons
who have been assigned with the following work:
• Installation
• Operation
• Maintenance
• Repair
• Troubleshooting
1.8 Applicable documents
f The operating instructions for the Autotool2000CPK
must be observed.
1.9 General information
We reserve the right to make technical changes
without notice.