PN/CAN Gateway, PROFINET/CANopen Slave | Version 2 | 1/26/2021 12
Installation must be carried out according to VDE 0100/IEC 364 and performed in accordance with
applicable national standards. The PN/CAN Gateway has protection rating IP20. If a higher protection
rating is required, the system must be installed in a housing or control cabinet. In order to ensure safe
operation, the ambient temperature must not exceed 60°C.
3.5 Installation position
The PN/CAN Gateway can be installed in any position. The front plate must be accessible in order to
plug in bus lines.
3.6 Minimum clearance
It is recommended to adhere to the minimum clearances specified when installing devices. Adhering
to these minimum clearances will ensure that:
• The modules can be installed and removed without having to remove any other system
components
• There will be enough space to make connections to all existing terminals and contacts using
standard accessories
• There will be enough space for cable management systems (if needed)
To Next Page
Loading...
