PN/CAN Gateway, PROFINET/CANopen Slave | Version 2 | 1/26/2021 8
1.6 Liability
The contents of this manual are subject to technical changes resulting from the continuous
development of products of Helmholz GmbH & Co. KG. In the event that this manual contains
technical or clerical errors, we reserve the right to make changes at any time without notice.
No claims for modification of delivered products can be asserted based on the information,
illustrations, and descriptions in this documentation. Beyond the instructions contained in the
operating manual, the applicable national and international standards and regulations must also be
observed in any case.
1.6.1 Disclaimer of liability
Helmholz GmbH &Co. KG is not liable for damages if these were caused by use or application of
products that was improper or not as intended.
Helmholz GmbH & Co. KG assumes no responsibility for any printing errors or other inaccuracies
that may appear in the operating manual unless there are serious errors about which Helmholz GmbH
& Co. KG was already demonstrably aware.
Beyond the instructions contained in the operating manual, the applicable national and
international standards and regulations must also be observed in any case.
Helmholz GmbH & CO. KG is not liable for damage caused by software that is running on the user’s
equipment which compromises, damages, or infects additional equipment or processes through the
remote maintenance connection and which triggers or permits unwanted data transfer.
1.6.2 Warranty
Report any defects to the manufacturer immediately after discovery of the defect.
The warranty is not valid in case of:
• Failure to observe these operating instructions
• Use of the device that is not as intended
• Improper work on and with the device
• Operating errors
• Unauthorized modifications to the device
The agreements met upon contract conclusion under “General Terms and Conditions of Helmholz
GmbH & Co. KG” apply.
To Next Page
Loading...
