PN/CAN Gateway, PROFINET/CANopen Slave | Version 2 | 1/26/2021 23
By calling the properties, a unique PROFINET name should be assigned to the PN/CAN Gateway and
the IP address checked for plausibility.
The name of the configured device must later be assigned to the physical device (see Chapter 6.3).
6.2.2 Parameterization
The first slot entry "Parameter" contains the module parameters for the behavior of the CANopen
master.
CAN bitrate: The available bit rates are 10, 50, 100, 125, 250, 500, 800 KBit/s and 1 MBit/s.
When using a DCF file, this parameter is ignored, because the bitrate is supplied in the DCF file.
To Next Page
Loading...
