34
4: Troubleshooting
TroubleShooting Tips
No eDriveTC Setup Menu on Outback S2: -
• Verify Outback S2 application software is the appropriate
version, “6.0 and above.”
• Verify the S Present light is lit on the eDriveTC console.
• Check CAN communication cable and connections.
No Steering Output at eDriveTC
Steering Adjust Menu: -
• Check the valve control cable and connections.
• Verify indicator lights, or voltage, at the hydraulic valve
solenoid connection.
• Verify hydraulic operation (refer to equipment specific
installation sheet for details).
Erratic or No Steering Corrections While Engaged: -
• Verify eDriveTC
console is securely mounted and correctly
oriented in the upright position.
• Check the gyro sensor data using eDriveTC Diagnostics Menu.
Drive the vehicle in a straight line. Sensor data should be near
zero. Turning to the left, data should display negative. Turning
to the right, data should display positive.
• Fine-Tune the steering control rate for smooth response and
minimum tracking errors.
To Next Page
Loading...
