Henny Penny LVE-204 User Manual (English)

Other manuals for Henny Penny LVE-204

Questions and Answers:

T
Thomas GarciaSep 7, 2025
What to do for Henny Penny LVE-204 Fryer control error code E-10?
- H
  Heidi Boyd DDSSep 7, 2025
  If your Henny Penny Fryer displays control error code “E-10”, it indicates an open high limit circuit. Allow the heating elements to cool for 15-20 minutes and then reset the high limit by pressing down and releasing the raised side of the switch for the vat that is not operating; these switches are located behind the right door next to the JIB. If the high limit does not reset, the high limit must be replaced.
T
thoSep 8, 2025
Why is Henny Penny Fryer filter motor pumping oil slowly?
- K
  Kaitlyn CordovaSep 9, 2025
  If the filter motor of your Henny Penny Fryer runs but pumps oil slowly, check for loose filter line connections and tighten them. The filter paper or pad may also be clogged, so try changing it.
C
Cory FrostSep 10, 2025
What to do if Henny Penny Fryer vat is under-filled?
- C
  Christine MaySep 10, 2025
  If the vat of your Henny Penny Fryer is under-filled, the JIB might be low or empty, so fill the JIB. Alternatively, the JIB oil line may be clogged or collapsed, so check the JIB line. The filter pan may also need cleaning, so clean the filter pan and change the paper or pad.
K
Kevin MoralesSep 12, 2025
What does error code E-31 mean on my Henny Penny Fryer?
- J
  Johnny ChandlerSep 12, 2025
  If your Henny Penny Fryer shows a control error code “E-31”, it means the elements are up. Lower the elements back into the vat to resolve this issue.
M
melissacurrySep 13, 2025
What does error code “E-4” mean on my Henny Penny LVE-204?
- K
  Kristen ParksSep 13, 2025
  If your Henny Penny Fryer displays “E-4”, the control board is getting too hot. Turn the switch to the OFF position, then turn it back to ON. Check the louvers on each side of the unit for obstructions.
J
Justin ConnerSep 14, 2025
What does error code “E-5” mean on my Henny Penny LVE-204 Fryer?
- D
  Dakota StephensSep 15, 2025
  If your Henny Penny Fryer displays “E-5”, the heating circuits and temperature probe should be checked. Turn the switch to the OFF position, then turn it back to ON.