Why is the oil not heating in my Henny Penny PXE-100 Fryer?
To address a Henny Penny Fryer where oil isn't heating, first ensure the drain valve is closed. If it is, the high-temperature limit may have tripped and needs resetting.
What to do if oil is not draining from my Henny Penny Fryer?
If your Henny Penny Fryer is not draining oil, it is possible that the drain valve is clogged. To resolve this, push a cleaning rod through the open drain valve.
What to do if my Henny Penny PXE-100 Fryer shows “E-4” “CPU TOO HOT” error?
If your Henny Penny Fryer displays “E-4” “CPU TOO HOT”, turn the switch off and then on again. If the error persists, it indicates the control board is overheating. Inspect the area behind the control panel for signs of overheating. Allowing the panel to cool may restore normal operation. If “E04” continues, the control needs replacement.
What to do if my Henny Penny Fryer shows “E-5” “OIL TOO HOT” error?
If your Henny Penny Fryer displays “E-5” “OIL TOO HOT”, try turning the switch off and then back on. If the “E05” error reappears, it means the oil is overheating, and the heating circuits and temperature probe should be inspected. Normal operation should resume once the unit cools down. If the error persists, the control likely needs to be replaced.
What to do if the pressure is not exhausting at the end of the cook cycle in my Henny Penny PXE-100 Fryer?
If your Henny Penny Fryer's pressure isn't exhausting at the end of the cook cycle, it could be due to a clogged solenoid or exhaust line. To resolve this, turn off the fryer and allow it to cool down to release the pressure in the frypot. Following this, have all lines, the solenoid, and the exhaust tank cleaned.
Why is the relief valve venting on my Henny Penny PXE-100 Fryer?
If the relief valve on your Henny Penny Fryer vents, it could be due to the operating pressure being too high or a clogged deadweight. To fix this, turn off the fryer and let it cool down to release the pressure in the frypot. Clean the deadweight.
Why is the pressure not building in my Henny Penny PXE-100?
If your Henny Penny Fryer is not building pressure, ensure you have enough product in the frypot and are using fresh oil. Also, verify that the metal shipping spacer has been removed from the deadweight assembly. Check the programming and reverse or replace the lid gasket if it's leaking.
What to do if Henny Penny Fryer is inoperative?
If the power switch is on but your Henny Penny Fryer is completely inoperative, it may be due to an open circuit. Ensure the fryer is plugged in and check the breaker or fuse at the wall.
Introduction to the Velocity Series PXE-100 pressure fryer.
Explains the meaning of NOTICE, CAUTION, WARNING, and DANGER symbols.
Critical instructions and warnings to prevent dangerous oil overflow situations.
Explanation of buttons, displays, and features on the control board.
Step-by-step guide for performing oil filtering operations.
Covers monthly and annual maintenance tasks for the fryer.
Configuration settings for units, language, melt cycle, and more.
Detailed list and explanation of various filter control parameters for optimization.
Common problems, their causes, and recommended solutions for the fryer.
Lists error codes displayed by the control system and their meanings.
General| Model | PXE-100 |
|---|---|
| Type | Electric Fryer |
| Control Type | Digital |
| Voltage | 208-240V |
| Temperature Range | 200°F to 375°F |
| Heating Element | Electric |
| Overall Dimensions | 15.75" W x 31.5" D x 45.25" H |
To Next Page