UKtKMIION
Fig. 2/4: Example of the programmed controller function with " StOP " termination command
40% 100%
T7 \ T8
/ vV I
T9
t2 13 t5 t6 t7 t8 t9 t
n 10 = StOP
The program sequence from a total of 9 segments must be entered, after which the healing and
ventilation is to be switched off.
The air speed levels to be set for each program segment are given in percent.
Starting up with programmed controller (unctions
|Example of display Remarks
instruction
Key(s)
Switch the unit on, refer to start-up with basic functions
Adjusting the overtemperature protection device: refer to Chapter 3
ontrol unit "off, unit
should not heal up
during this input
all main program
memory
ca. 3 Sek.
set
n n I
J U.U
I I
Inside temperature,
green signal lamp
lights up continuously
Program segment
"n I" is displayed,
programmable digit
flashes
22/34
50 042 750
Issue: May, 1994
To Next Page
