44
•
Use starter switch:
With the throttle closed, press the starter
switch.
(5) i3s switch
5
•
Make sure whether the i3s switch (5) is
in “ON” or “OFF” position.
(3) Ignition switch (4) Programmed FI
malfunction indicator lamp (MIL)
NOTE
The engine will not start if the throttle is fully
opened as programmed FI system will cut off
the fuel supply.
•
Use kick starter:
With the throttle closed, operate the kick
starter with a rapid and continuous motion.
•
Continue warming up the engine until it
runs smoothly and responds to the throttle.
NOTE
If MIL remains “ON” even if the vehicle is
started, there is an abnormality in the
programmed FI system. It is recommended to
reduce the speed and drive to the Authorised
Hero MotoCorp workshop for check-up.
•
Do not leave the vehicle unattended while
the engine is warming up.
•
Snapping the throttle or fast idling for more
than 5 minutes at normal air temperature
may cause exhaust pipe discolouration.
3
4
To Next Page
Loading...
