43
CAUTION
!!
Do not attempt to start the engine and run the
vehicle without a battery. This may lead to
electrical and electronic components failure.
the garage door closed.
Your vehicle's exhaust contains poisonous
carbon monoxide gas. High levels of carbon
Even with the door open, run the engine only
long enough to move your vehicle out of the
garage.
monoxide can collect rapidly in enclosed areas
such as a garage. Do not run the engine with
Operate the kick starter or electric starter
switch for slightly longer than usual without
opening the throttle if the vehicle has been left
standing for a long time or when the fuel tank
has just been refilled.
•
Lock the rear wheel by pressing the
integrated brake lever (1) and locking
the lever lock (2 ).
The electric starter will only work when the
front or integrated brake lever is operated.
•
Park the vehicle on its main stand.
2
(1) Integrated brake lever (2) Lever lock
Always follow the proper starting procedure
described below. This vehicle has a fuel
injected system
STARTING THE ENGINE
•
Contact with the rotating rear wheel can
injure you.
•
Set the lever lock when the vehicle is on its
main stand.
NOTE
•
In case the engine gets started, cranking
(starter relay engagement) of engine will
stop after engine reaches 900 r/min.
•
When cranking the engine by using brake &
starter switch or brake & slight throttle,
cranking of engine will stop after 5 seconds,
if engine does not start. After that, brake &
starter switch or brake & slight throttle is
required to crank the engine.
•
Confirm that the programmed FI
malfunction indicator lamp (MIL) (4) glows
continuously and then should go “OFF”
once the engine is started.
•
Turn the ignition switch (3) to “ON” ( )
position.
1
To Next Page
Loading...
