68
CAUTION
!!
•
Do not attempt to start or ride the vehicle
without a charged battery, it can cause
fusing of the bulbs and permanent damage
to certain electrical components.
•
Turn the ignition switch "OFF" before
checking or replacing the fuse to prevent
accidental short-circuiting.
•
If the replacement fuse of the same rating
burns out in a short time, there is probably a
serious electrical problem on your vehicle.
Leave the blown fuse in that circuit and have
your vehicle checked by your Authorised
Hero MotoCorp workshop.
SUSPENSION
Inspection
•
Check the front forks by locking the front
brake and pumping the front fork up and
down vigorously. The suspension action
should be smooth and there should be no oil
leakage.
•
Check the rear shock absorber by pushing
hard downwards on rear grip while the
vehicle is not parked on stand. The vehicle
action should be smooth and there should
be no oil leakage.
BULB REPLACEMENT
Refer to the safety precautions (page 54).
The bulb becomes very hot while the lamp is
“ON”, and remains hot for a while after it is
turned “OFF”. Be sure to let it cool down
before servicing.
Do not put finger prints on the headlamp bulb,
as they may create hot spots on the bulb and
cause it to break.
•
Be sure to turn the ignition switch “OFF”
when replacing the bulb.
•
Do not use bulbs other than specified.
•
After installing a new bulb, check that the
lamp operates properly.
Wear clean gloves while replacing the bulb. If
you touch the bulb with your bare hands, clean
it with a cloth moistened with alcohol to
prevent its early failure.
(a) Headlamp bulb
•
Remove the headlamp assembly (page 40).
•
Remove the headlamp bulb (4) without
turning.
•
Disconnect the headlamp connector (1).
•
Remove the dust cover (2).
•
Release the clip (3) from its position.
Front Rear
To Next Page
Loading...
