59
CAUTION
!!
•
Do not wash using any solvent.
•
Do not blow compressed air.
Pre oam f element
The pre foam element should be serviced at
regular intervals . Service more (page 55)
frequently when riding in unusually wet or
dusty areas.
Cleaning
•
Wash the pre foam element in kerosene.
•
Spread 5ml (4 to 5 drops) of SAE 90
grade at different locations on pre foam
element.
•
Replace air cleaner element once in every
15000 km or early replacement may be
required when riding in dusty areas.
•
element At 12000 km inspect if air cleaner
(viscous type) is choked. If found choked,
replace the air cleaner element to keep the
engine healthy.
•
Replace pre foam element or viscous element
at any point of time, if found damage.
NOTE
•
Squeeze it in a manner so that oil will spread
on complete surface of pre foam element.
Installation
•
Install the air cleaner element holder
component (new, in case of replacement).
•
Install the air cleaner cover.
THROTTLE OPERATION
Cable Inspection
•
body cover (page 36)Install the .
Check for smooth rotation of the throttle grip
from the fully open to the fully closed position.
Check at full left and full right steering
positions. Inspect the condition of the throttle
cable from the throttle grip down to the
throttle body. If the cable is kinked, chafed or
•
Clean the air cleaner sub assembly case (4)
using a shop towel.
•
Install the pre foam element.
CAUTION
!!
Do not wring the filter element with both
hands.
WASH IN KEROSENE
SAE 90 Grade
SQUEEZE
TO SPREAD OIL
To Next Page
Loading...
