62
Engine oil replacement/
Oil strainer cleaning
•
Place an oil drain pan under the crankcase
and remove the oil drain bolt (1) and
sealing washer (2).
•
Remove the oil level dipstick.
Change the engine oil with the engine at
normal operating temperature and the vehicle
on its main stand to assure complete and rapid
draining.
•
Remove the oil strainer screen cap (3).
(1) Drain bolt (2) Sealing washer
(3) Oil strainer screen cap
3
2
•
Clean the oil strainer screen.
•
Check that the oil strainer screen, sealing
rubber and cap O-ring (6) are in good
condition.
•
The spring (4) and oil strainer screen (5)
will come out when the oil strainer screen
cap is removed.
• Fill crankcase with the recommended grade
of oil:
• Install the oil strainer screen, spring and oil
strainer screen cap. Install the drain bolt
with new sealing washer.
At draining: 0.70 litre
At engine disassembly: 0.80 litre
• Switch “OFF” the i3s switch.
• Start the engine and let it idle for 2-3
minutes. Stop the engine and ensure that
the oil level is at the upper level mark on the
oil level dipstick with the vehicle upright on
flat level surface. Ensure there are no oil
leaks.
• Install the oil level dipstick.
(4) Spring (5) Oil strainer screen (6) O-ring
6
1
5
4
To Next Page
Loading...
