30
•
Bharat Petroleum Corporation Limited.
Check engine oil level each day before
operating the vehicle.
Engine oil level inspection/Top up
process
The oil level dipstick (1) is on the right
crankcase cover for measuring oil level. Oil
level must be maintained between the upper
(2) and lower (3) level marks on the oil level
dipstick.
Do top up if oil level reaches towards the lower
level mark or every 3000 km whichever is
earlier.
•
Savita Oil Technologies Limited.
OIL CAPACITY: 1.25 liters
(1) Oil level dipstick (2) Upper level mark
(3) Lower level mark
•
If required, add the specified oil up to the
upper level mark. Do not overfill.
•
Reinstall the oil level dipstick and check for
oil leaks.
Oil circulation inspection
•
To drain the oil, remove the oil level dipstick
and drain bolt (1) with sealing washer (2).
•
Remove the oil level dipstick, wipe it clean
and insert without screwing it in.
•
Remove the oil level dipstick and check the
oil level.
•
Quantity of oil to be filled is 1.1 liters
(approx.) during oil change when right
crankcase cover is not removed.
Engine oil replacement process/
Drain engine oil with the engine warm and the
vehicle on its main stand.
•
After checking the oil circulation, install the
tappet inspection cover.
•
Remove the tappet inspection cover. Slowly
accelerate and check the engine oil entry
into the cylinder head, engine oil will splash
out from the tappet inspection cover
opening.
•
Reinstall the oil level dipstick with a new
O-ring.
•
Start the engine and allow it to idle for few
minutes.
•
After the oil has completely drained,
reinstall the drain bolt with a new sealing
washer (2).
•
Fill the crankcase through the oil filler hole
with (approximately) of the 1.1 litres
recommended grade oil.
3
2
UPPER
LOWER
•
Park the vehicle on its main stand.
•
Turn the i3s switch to “OFF” position.
•
Start the engine & let it idle for 3-5
minutes.
•
Stop the engine and wait for 2-3 minutes.
1
To Next Page
Loading...
