speed, close the throttle, press the clutch
nd
lever and shift to gear by depressing the
2
gearshift pedal.
Ÿ The sequence is repeated progressively to
rd
th
shift 3 and 4 (top gear).
Recommended shifting speed
st nd
1 2
0-20 km/hr 15-30 km/hr
rd
th
3 20-40 km/hr 4 30 km/hr and above
22
Flooded Engine
If the engine fails to start after repeated
attempts, it may be flooded with excess fuel.
To clear a flooded engine, turn the ignition
switch “OFF” and turn the bystarter to “OFF”.
Close the throttle fully and crank the engine
several times with the kick starter. Turn the
ignition switch “ON” and start the engine
without using bystarter.
Running in
During first 1000 km, do not operate the
vehicle at more than 65 km/hr speed in
top gear, 45 km/hr in third gear, 30 km/hr
in second gear and 15 km/hr in first gear.
Avoid full throttle operation.
During initial running-in, newly machined
surfaces will be in contact with each other and
these surfaces will wear-in quickly. Running in
precautions till 1000 km will reduce initial
wear of engine components and increase its
service life.
RIDING
Ÿ After the engine has been warmed up, the
vehicle is ready for riding.
Ÿ While the engine is idling, press the clutch
lever and depress the gearshift pedal to shift
st
into 1 (low) gear.
Ÿ Slowly release the clutch lever and at the
same time, gradually increase engine speed
by opening the throttle. Coordination of the
throttle and clutch lever will assure a smooth
positive start.
Ÿ When the vehicle attains a moderate
CAUTION
!!
Do not shift gears without operation of clutch
and without closing the throttle otherwise this
would lead to damage of gears.
BRAKING
Ÿ For normal braking, close the throttle and
gradually apply both front and rear brakes
simultaneously while shifting down gears to
suit your road speed.
Ÿ For sudden deceleration/quick stopping,
close the throttle and apply the front and
rear brakes simultaneously.
To Next Page
Loading...
